Setting Up; Mains Connection; Operation - Parkside PHD 100 C2 Originalbetriebsanleitung

Setting up

• Screw the equipment side of the
B
high-pressure hose connection
(2) to the high-pressure hose con-
nection (3) on the equipment.
• Screw the gun side of the high-
pressure hose connection (1) to
the spray gun (10)
• Establish the water supply by
connecting the rapid-action wa-
ter supply connector to the water
connection with sieve insert (8).
• Connect to the spray gun (10)
C
by inserting and screwing in the
jet tube (11).
• If the jet pipe (11) is itted, screw
in with the jet pipe (11) to con-
nect either the adjustable fan
nozzle (12) or the high pressure
nozzle (13).
Screw in to connect the deter-
gent container with nozzle (14)
directly to the spray gun (10).
With using the cleaning agent
container with the nozzle (
14), pour only cleaning agent
into the container. It is sucked in
automatically.
The width of the jet can be increased by
turning the end of the nozzle to the left. To
reduce the width of the jet, turn the end of
the nozzle to the right.

Mains connection

The pressure washer you have acquired is
already itted with a mains plug. The pres-
sure washer must only be connected to an
earthed socket 230 V ~ 50Hz.
Only operate the pressure washer
after all the above points have been
observed.
• Ensure that the pressure washer is
turned off by its ON / OFF switch (
5).
• Insert the mains plug into the mains
socket

Operation

• Connect the equipment to the water
tap. Observe the regulations for the
use of a system separator.
• Turn on the water tap entirely.
Never operate the pressure washer
with a closed water tap. Dry run-
ning will damage the washer!
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
standing irmly and that you
are holding the gun (
securely, otherwise you could
injure yourself or other peo-
A
ple.
• Switch on the pressure washer with the
ON / OFF switch (
• Pull the lever of the gun (
on the washer.
• Hold the switch-on lever of the gun
( 10) until there is no more air in the
A
pressure washer.
A 5).
Releasing the lever will switch
off the washer, but the pressure
within the system is retained.
GB
A
A 5)
10) to turn
A
45