DO NOT THROW AWAY THESE INSTRUCTIONS
DESCRIPTION OF THE APPLIANCE (Fig. 1)
1
Footsoperated cord rewinder button
2
Suction power regulation dial
3
Dust container full indicator light
4
Footsoperated on/off switch
5
Dust container
6
Dust container handle
7
Dust container lock/release button
8
Filter
9
Suction device coupling
10 Top carry handle
ATTACHMENTS
Floor brush (15)
Ideal for cleaning any type of surface. Use the device on the top of the attachment to:
s retract the bristles when cleaning carpets or rugs;
s lower the bristles for smooth floors such as PVC, parquet or tiles.
Parquet floor brush (19)
Suitable for cleaning delicate surfaces.
Narrow suction nozzle with brush (11)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device.
VACUMM CLEANER ASSEMBLY
WARNING: Before fitting or removing the attachments, always make sure that the vacuum cleaner
has been unplugged from the power mains.
s Fit the suction device (18) into the air inlet opening (9) and press it in until it clicks into place. To
remove it, it is necessary to press the two release buttons (14) at the same time and to pull it out
(Fig. 2).
s Insert the telescopic tube (16) into the handle (Fig. 3).
s Push the slider device (17) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). Then simply release the slider and the device will return to its original position.
s Fit the required attachment to the telescopic tube.
USING THE APPLIANCE
Caution: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
11 Narrow suction nozzle with brush
12 Handle
13 Manual air inlet valve
14 Release buttons
15 Floor brush
16 Telescopic tube
17 Slider device
18 Suction device
19 Parquet floor brush
s 7 s
EN