- Adjust ventilation fan
With this function you can adjust the ventilation fan.
• Select "FANS" by pressing [UP] or [DOWN].
• Press [MODE/ENTER] to confirm; the display shows "AUTO".
• Press [UP] to select "HIGH" or "AUTO".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Rest
- Reset
With this function you can Reset the device via the Control Board.
• Select "REST" by pressing [UP] or [DOWN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Restore factory settings
With this function you can restore the factory settings of the device. All settings will be set back to the
default values (shaded). Any edited scenes will be lost.
• Select "LODA" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DOWN] to select "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Wireless DMX
From factory, this projector is prepared for wireless data transmission (W-DMX). With this function, you
can de-activate W-DMX or log out the projector.
• Select "WDMX" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] to select "ON" if you wish to enable this function or [DOWN] to select "OFF" if you don't.
• With the function "REST" you can log out the projector from the wireless sender.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
Ver
- Software version
With this function you can display the software version of the device.
• Select "VER" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "V-X.X", "X.X" stands for the version number, e.g. "V-1.0",
"V-2.6".
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 3
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DOWN] to select "ADJU".
56/116
51838710_V_1_1.DOC