Stahl 9440/22-01-11 Betriebsanleitung Seite 52

Parameterization and Commissioning
EN
9.1.1 Start-up
EN
Display
EN
FBAdr
EN
5
EN
EN
9.1.2 Setting the Fieldbus Address
EN
EN
EN
EN
EN
Display
EN
FBAdr
EN
5
EN
CPM
EN
9440/15-01-11
EN
CPM
EN
FB addr :
EN
set FB address
select:
EN
EN
EN
EN
accept changes ?
yes -> CPM reset
EN
EN
EN
accept changes ?
No
22
CPU & Power Module for Zone 1 / Div. 1
Series 9440/22, 9490
Settings
• After connecting the auxiliary power, the device will boot.
FB I/O
• After successful completion of the booting process, the LCD display
OK OK
switches to the system level (shown on the left).
12258E00
The fieldbus address can be set only if the device is not in the Data Exchange
mode.
Settings
• Initial display (shown on the left)
FB I/O
OK OK
12258E00
• Press ▲ and ▼ simultaneously. The following display appears
active
(shown on the left).
12259E00
• Press ▲ and ▼ simultaneously. The following display appears
active
(shown on the left).
5
12260E00
• Press ▲ and ▼ simultaneously. The following display appears
(shown on the left).
5
12261E00
• Press ▲ or ▼ until the desired fieldbus address has been set.
When pressing the button continuously the value changes rapidly.
The setting range goes from 0 to 127.
• Press ▲ and ▼ simultaneously. The following display appears
(shown on the left).
12262E00
• Press ▲ and ▼ simultaneously. The settings are applied.
The device boots again.
or
• Press ▲ or ▼ . The following display appears
(shown on the left).
12263E00
• Press ▲ and ▼ simultaneously. The setting procedure is cancelled.
After setting the fieldbus address, the device boots again.
The fieldbus address is permanently saved and is also available after reset or
recommissioning.
162277 / 9440607310
2018-08-13·BA00·III·en·06