Lanaform Trimax Bedienungsanleitung Seite 4

• Do not cover the appliance when in operation.
EN
• Extended use could cause the product to overheat and reduce its lifespan. To avoid these inconveniences, turn off the
unit and let it cool down before turning it on.
IMPORTANT
• If you have any doubts regarding your health, consult your doctor before using this product. The following categories
of users must obtain doctor's approval before using this appliance:
- Persons using a pacemaker.
- Patients suffering from cardiopathy.
- Patients suffering from a deformation of the vertebral column or undergoing treatment for a fracture or fracture
deformity.
- Pregnant women or patients suffering from a fever after an operation.
- Patients suffering from an acute illness or a serious form of cancer.
- Contagious patients suffering from skin disease.
- Patients who have not yet fully recovered from an operation.
- Patients suffering from diabetes.
- Persons suffering from physical problems capable of hindering their ability to use the controls.
• Use of this unit must be forbidden for children.
• Do not use this product for more than 20 minutes per session.
• Never use this product directly on swollen or inflamed areas, open wounds or rashes.
FEATURES
1) Vibrating surface plate
2) Infra-red light
3) Massage points
4) Lead
5) Remote control
6) Support
7) Control panel
USER MANUAL
• Place the machine on a flat surface and plug it into the power supply.
• Press the «ON/OFF» button; the machine will switch on and a light will light up. The LCD screen will display the value 06;
this means that the vibration intensity level is set to 6. The initial setting is in manual mode: vibration speed 6, timer set
to 10 minutes and infra-red thermal treatment set to speed 3.
• Press ▲ to increase the vibration speed and ▼ to decrease the speed. Each press represents an increase or decrease of
one level. At the same time, the screen will display the number corresponding to the speed modification. The settings
range in speed from 0 to 12 with 0 stopping the massage.
• Press «TIME» to select the treatment time. Each press on this button enables you to successively move between the
10-minute – 15-minute – 20-minute and 10-minute modes. The initial setting is set to 10 minutes.
• Press «INFRARED» to change the thermotherapy. The range of use of the infra-red light fluctuates from H0 to H5, in
4
[3]
[2]
[1]
[7]
[4]
[6]
[5]