Vented Example High-Pass Set At 30Hz; Amplifier Wiring; Power Connections - Orion HCCA10002 Handbuch

6ENTED%XAMPLE(IGH-0ASS3ETAT30(Z
Vented enclosures benefit most from the Intelli-Q. Up to 10 dB of
boost is capable at the box tuning frequency of 30 Hz. With +10dB
of boost, the woofer has more output down to 22 Hz. The excursion
below the tuning frequency has been greatly reduced.
Figure 12
Figura 12
Abbildung 12
Figure 13
Figura 13
Abbildung 13
2012 MD Audio Engineering. All rights reserved.

AMPLIFIER WIRING

0OWER#ONNECTIONS
s Orion HCCA10002 Fuse Size: 100 Amp.
Orion HCCA10004 Fuse Size: 100 Amp.
s
s Power connections accept up to 4 AWG wire.
4 AWG power and ground wire must be used for optimal per-
s
formance.
s Connect 12V+ to the battery through a fuse holder. This connec-
tion provides +12V main power to the amplifier.
s Power wire must be fused no more than 12" from battery.
Ground amplifier to a good chassis ground as close as possible to
s
the amplifier.
s Recommended fuse is 100A for both amplifiers.
s Connect REM terminal to remote turn-on lead from source unit.
This connection provides +12V power to turn-on the amplifier.
Add extra ground wire between the negative terminal of the
s
battery and the chassis.
NOTE: The addition of a ground wire from the battery to the chassis
of the vehicle improves the ability of the battery to supply power to
the amplifier. This is recommended because the current delivery of the
factory electrical system was designed only to accommodate electron-
ics supplied by the auto manufacturer.
11