Hitachi RAK-60PPA Bedienungsanleitung Seite 30

INFO FUNCTION
By pressing (INFO) button, temperature around remote controller and monthly power consumption
●
will be displayed on the remote controller.
After changing the batteries, direct the remote controller towards the indoor unit and press
●
button.
Current calendar and clock will be transmitted from indoor unit.
In order to receive information from indoor unit, the distance between remote controller and receiver of indoor
●
units is within 2 meters.
NOTE
In case failure occurs to the air conditioner, by pressing
●
be displayed.
Direct the remote controller towards the receiver of indoor unit (within 2 meters in front of indoor unit)
and press (INFO) button. Wait for 2 seconds for signal transmission.
An error code will be displayed.
Call service center and inform the error code.
■ To check temperature around remote controller
Press (INFO) button.
1
Temperature will be displayed for 10 seconds.
■ To check monthly power consumption
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press
for 2 seconds for signal transmission.
While temperature around remote controller is displayed, press
(INFO) button repeatedly. The display will show as below:
this month power consumption amount for heating
power consumption for heating
amount for cooling
cooling temperature around remote control
consumption amount for heating ...... cyclically.
If indication is not given, bring remote controller closer to the
●
receiver of the indoor unit.
lndicated value shall be regarded as a guide only.
●
■ Current calendar and clock can be retrieved
from indoor unit
Direct the remote controller towards the receiver of indoor unit (within 2
meters in front of indoor unit) and press
for 2 seconds for signal transmission.
Once received the current calendar and clock, check whether they
are correct or not by pressing
If there is no power supply to indoor unit or calendar and clock
●
have not been set, INFO function cannot be used for sending or
receiving information.
– 3 0 –
– 30 –
(INFO) button. Wait
this month power consumption
last month power consumption amount for
(INFO) button. Wait
(CLOCK) button.
(INFO) button, an error code will
(INFO)
last month
this month power