Maintenance And Storage - Lanaform Aroma spring Bedienungsanleitung

Important notes:
EN
- Only use clean and fresh water, preferably water that has been boiled and cooled.
- Do not move or refill the reservoir when the fountain is working.
- If the water flow is not sufficient, adjust this using the button on the pump (Figure 2 (i)).
- When there is no more water in the reservoir the water level indicator will turn red. Refill your fountain.
- Caution: EVEN THOUGH THERE IS A SAFETY DEVICE THAT STOPS THE TRANSDUCER WORKING, DO NOT LEAVE THE DEVICE
CONNECTED WHEN YOU ARE NOT USING IT.
ADDITIONAL INFORMATION RELATING TO THE USE OF ESSENTIAL OILS
- Before using the essential oils, please check the harmful effects that use of these products may have on your health.
- Always choose quality essential oils that are pure, 100% natural and intended for diffusion. Use them in moderation and
with care. Follow the instructions and warnings stated on the packaging of the essential oils, in particular by ensuring
that:
• Pregnant women, people with epilepsy, asthmatics and people suffering from allergies and those with heart
problems or serious illnesses do not use essential oils.
• Essential oils should only used for periods not exceeding 10 minutes in a baby's room (under 3 years old) and only
when the baby is not actually in the room.
• Make sure that children and minors do not play with and use the device.
- Just a few drops (3 to 4 drops at most) of essential oils are sufficient to ensure that the device works properly and the
scent is being diffused. Excessive use of essential oils could damage the device.
- First pour water in the reservoir, then add a few drops of essential oils.
- Lanaform® cannot be held liable in the event of accidental damage resulting from any use contrary to the instructions
given in this manual.

MAINTENANCE AND STORAGE

If the water contains too much calcium and too much magnesium, it may deposit a "white powder" in the device. If this
foam is deposited on the transducer (ceramic ring emitting ultrasounds, Figure 1 (6)), this will prevent the device from
working properly.
We recommend:
1) Using water that has been boiled and cooled each time it is used.
2) Cleaning the reservoir every 2 days and cleaning the transducer every week.
3) Changing the water in the reservoir every 2 days.
4) Cleaning the device (see explanations below) and making sure that all its parts are completely dry when it is not in
use.
To clean the transducer (Figure 1 (6)):
1) Put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes.
2) Brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the reservoir of the base in clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
6