Setting Up The Led Emitter, Camera And Movement Sensor - lidl WAL 14 A1 Bedienungsanleitung Und Sicherheitshinweise

Finally, use the screwdriver (B) to turn the screw
(11) from underneath through the camera
housing into the mounting plate (10).
The screw (11) is a special screw
to guarantee extra protection
against theft. Always use this
screw! It is imperative that the
screw (11) is fitted to prevent theft
of the whole camera body.
Switch the power supply back on again.

7.5. Setting up the LED emitter, camera and movement sensor

You can adjust the camera (3), the LED emitter (1) and the movement sensor (7) to your requirements
independently of one another:
The LED emitter (1) can be swivelled and tilted, the camera (3) swivels and tilts up and down, the
movement sensor (7) swivels.
Use the adjuster ring (6) to adjust the horizontal detection range of the movement sensor.
WAL 14 A1
English - 13