Malfunction
The espresso is cold.
The pump is unusually
noisy.
The crema is too light
(the espresso runs out
of the sieve holder
quickly).
The crema is too dark
(the espresso runs out
of the sieve carrier
slowly).
The milk does not froth.
Disposal
Disposal of the appliance
Do not dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of the European WEEE
(Waste Electrical and Electronic Equipment) Directive 2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please comply with all applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
■
86
│
GB │ MT
Cause
• The appliance was not
preheated.
• The green heating-up control
lamp
has not yet glowed.
• The cups were not pre-warmed. • Pre-warm the cups.
• The water tank
is empty.
• Not enough espresso powder.
• The espresso powder is too
coarsely ground.
• Too much espresso powder.
• The powder is too finely ground
or moist.
• The sieve is blocked.
• The milk is not cold enough.
• The milk frother
is dirty.
Solution
• Preheat the appliance.
• Wait until the green
heating-up control
lamp
lights up.
• Fill the water tank
with water.
• Use more espresso
powder.
• Use only espresso
powder specially manu-
factured for espresso.
• Use less espresso
powder.
• Use only espresso
powder specially manu-
factured for espresso.
• Clean the sieve.
• Use milk from the
refrigerator.
• Clean the milk frother
SEM 1100 B3
.