Installation Instructions; Flow Diagram - HANSGROHE Croma 100 Multi Combi 27052000 Gebrauchs- Und Montageanleitung

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
Children as well as adults with physical, mental and/
or sensoric impairments must not use this product
without proper supervision. Persons under the influ-
ence of alcohol or drugs are prohibited from using
this product.
Do not allow the streams of the shower touch sensi-
tive body parts (such as your eyes). An adequate
distance must be kept between the shower and you.
The product may not be used as a holding handle. A
separate handle must be installed.
Shower hoses are only suitable for a connection
from the shower to the fitting. Never fit a shut-off
device between the fitting and the hose.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• During installation of the product by qualified trained
personnel, make sure that the entire fastening surface
is even and smooth (no protruding seams or tile
offset), that the finish of the wall is suitable to apply the
product and has no weak points.
• The filter insert must be use to protect the shower
against incoming dirt by pipework. Incoming dirt leads
to defects or/and can damage parts of the shower;
such caused faults voids all liability and guarantee
claims.
• Thermostatic mixer Operation / Assembly see en-
closed brochure
• Optimal functioning is only guaranteed with the com-
bination of Hansgrohe hand showers and Hansgrohe
shower hoses.
4
English
Technical Data
Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
Symbol description
Assembly see page 34
Do not use silicone containing acetic acid!
Dimensions (see page 31)

Flow diagram

(see page 33)
Croma 100 Vario 28535000 / 28537000
 

Croma 100 Multi 28536000 / 28538000
  
Operation (see page 36)
Cleaning (see page 37) and en-
closed brochure
Spare parts (see page 38)
Special accessories (order as an
extra)
tile-matching-disk chrome plated
#97450000 (see page 38)
Test certificate (see page 40)
max. 0,6 MPa
0,1 - 0,4 MPa
max. 60°C
max. 70°C / 4 min
