DeWalt DW082 Handbuch Seite 37

• Although the tool corrects small out-of-level errors automatically, when
it is bumped, re-adjustment to balance or set-up may be required.
• If the tool has been dropped or has tipped over, have the laser head
calibrated by a qualified repair agent.
Switching on and off (fig. D)
• To switch the tool on, press the on/off switch (1).
• To switch the tool off, press the on/off switch (1) again.
Transferring a position mark
The tool produces two laser dots in opposite directions to transfer a mark.
• Use the one beam to locate the mark and transfer the mark using the
opposite laser beam.
Optional accessories
Consult your dealer for further information on the appropriate accessories.
Maintenance
Your D WALT power tool has been designed to operate over a long
E
period of time with a minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and regular cleaning.
Field calibration check
The field calibration check must be performed securely and accurately to
make a correct diagnosis. Whenever an error is registered, have the tool
calibrated by a qualified repair agent.
Always have the laser head calibrated by a qualified repair
agent.
Plumb check
• Place the tool on the floor in an area parallel to a vertical surface of
about 15 m height.
• Mark a marking on the floor.
E N G L I S H
37