Replacing The Lamp - JUNO JDWK907S0 Bedienungsanleitung

58
The dishwasher must be set to
a low temperature and a short
cycle. The grease filter may
discolour, it has no influence on
the performance of the
appliance.
5. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if applicable.
Replacing the charcoal filter
The charcoal filter must be replaced if the
filter alarm is on.
Refer to the filter alarm in this
chapter.
The time of saturation of the charcoal filter
varies depending on the type of cooking
and the regularity of cleaning the grease
filter.
WARNING! The charcoal filter
is NON-washable! The filter
cannot be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in this
chapter.
2. Turn the filter counterclockwise (1) and
then pull (2).
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
1
2
To mount the filters back follow the steps
in reverse order.
Filter alarm
Refer to activating and
deactivating the filter alarm in
daily use chapter.
Refer to cleaning the grease
filter in this chapter.
Refer to cleaning the charcoal
filter or replacing the charcoal
filter (depends on filter type).
To reset the alarm:
Touch the for 3 seconds.

Replacing the lamp

This appliance is supplied with a LED
lamp. This part can be replaced by a
technician only. In case of any malfunction
refer to "Service" in the "Safety
Instructions" chapter.