Panasonic AVC-Intra AJ-YBX200G Bedienungsanleitung Seite 7

Installation into the AJ-HPM100
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock, do not perform any servicing other than as directed in the operating instructions
unless you are qualified to do so.
1
Unscrew the two screws from the AJ-
YBX200G to remove heat sink 1.
Heat sink 1
2
Unscrew the three screws and nuts from
the AJ-YBX200G to remove heat sink 2.
Heat
sink 2
3
Screws
(black)
4
5
Screws
(black)
Remove the cooling sheets if they remain
on the AJ-YBX200G after removing heat
sinks 1 and 2.
Cooling sheet
Make sure that the power of the AJ-
HPM100 is turned off.
Unscrew the 7 screws from the AJ-
HPM100 to remove the top panel.
Screws
Cooling
sheet
E-6