Alutech Levigato LG Serie Montage- Und Betriebsanleitung Seite 28

ADjUSTMENT
In three seconds the switch to the waiting mode for the signal from the next
remote control will take place. To exit the programming mode press the
10
button
The table 13 describes the settings of deleting the remote control when it is absent but the
information for the remote control number in the drive memory is available.
Similarly to tab. 12 items 1 to 4, enter the menu 'P2' and select the setting 'f9'
1
After the appearance of 'f9' inscription press the button
2
The number of the first recorded remote control will appear on the display.
3
With the button
Press the button
4
the remote control with the selected number is deleted from the memory
In three seconds the next number of the remote control will appear on the
display. To exit the programming mode press the button
5
15 seconds (until automatic exit the setup menu)
Deleting all remote controls
Press and hold the button
1
programming mode
2 After the appearance of 'P1' inscription press the button
3 After the appearance of 'P2' inscription press the button
4 With the button
5 After the appearance of 'f0' inscription press the button
After the appearance of '– –' inscription press and hold the button
5 secs. A dot will appear on the display, this means that all remote controls are
6
deleted from the memory
To exit the programming mode press the button
7
15 seconds (until automatic exit the setup menu)
26
or wait for 15 seconds (until automatic exit the setup menu)
or
. A dot will disappear from the display, this means that
or
LEVIGATO DRIVES (LG SERIES)
select the of remote to delete
for about 5 secs to enter the
select the setting 'f0'
twice or wait for
| LEVIGATO ANTRIEBE (SERIE LG)
or wait for
for
| COMMANDES LEVIGATO (SERIE LG)
Table 13
Table 14