Assigning An Application Software To The Function Key On The Remote Commander (For Vpl-Px15 And Vpl-Fx50); Setting Up From A Computer - Sony VPL-PX15 Bedienungsanleitung

Setting the date and clock
The clock is displayed on the task bar of the Network
Projector window. To set the date and time, follow the
steps below.
1
From the Start menu of the Network Projector
window, click Control Panel.
2
Double-click the Date/Time icon.
3
Set the date and time.
Assigning an application software to the
FUNCTION key on the Remote
Commander (for VPL-PX15 and VPL-FX50)
If you assigned an application to the FUNCTION 1 or
2 key on the supplied Remote Commander, a touch of
the key enables you to start that application. The
screen keyboard is assigned to the FUNCTION 3 key
at the factory, and you cannot reassign or cancel that
assignment.
For detailed information about the screen keyboard, see
page 35 (GB).
1
From the Start menu of the Network Projector
window, click Control Panel.
2
Double-click the Launch Keys icon.
The Launch Keys Settings dialog box appears.
3
Click Browse for the key (1 or 2) to which you
want to assign an application software, then click
the application you want from the application list.
4
Repeat step 3 if you want to assign an application
to the other key.
5
Click the OK button.

Setting Up from a Computer

Notes
• Connect a single computer you are using for setups to
the projector if the IP address of the projector is not
changed from the factory-preset one.
• If the browser of your computer is set to "Access the
Internet using a proxy server," enter the IP address of
the projector in the box "Access the Internet without
using a proxy server" when you have access to the
projector from your computer.
• The computer may not accept the password for the
projector, depending on the version of the browser. In
this case, restart the browser.
Opening the setup window
1
Start the computer's browser software (Internet
Explorer 4.0 or later versions, or Netscape
Navigator 4.5x or 4.7x version).
2
Type "http://xxx.xxx.xxx.xxx (for the IP address of
the projector)/setup".
If the IP address is not changed from the factory-
preset one, type "http://192.168.0.1/setup" (when
using a LAN PC card) or "http://192.168.0.2/
setup" (when using the ETHER connector).
If the number of the IP address starts from 0 (zero),
enter the number without 0.
Example: 192.168.000.001 c 192.168.0.1
The Password dialog box appears.
3
Enter the Name and Password for Administrator.
If the Password setting is not changed from the
factory-preset one, enter "root" in the Name text
box.
The Setup window appears.
13
(GB)