Enerpac BP1 Series Bedienungsanleitung Seite 2

CAUTION: Keep hydraulic equipment away from
fl ames and heat. Excessive heat will soften packings
and seals, resulting in fl uid leaks. Heat also weakens
hose materials and packings. For optimum performance do not
expose equipment to temperatures of 65°C [150°F] or higher.
Protect hoses and cylinders from weld spatter.
DANGER: Do not handle pressurized hoses. Escaping
oil under pressure can penetrate the skin, causing
serious injury. If oil is injected under the skin, see a
doctor immediately.
WARNING: Only use hydraulic cylinders in a coupled
system. Never use a cylinder with unconnected couplers. If
the cylinder becomes extremely overloaded, components
can fail catastrophically causing severe personal injury.
WARNING: BE SURE SETUP IS STABLE BEFORE
LIFTING LOAD. Cylinders should be placed on a fl at
surface that can support the load. Where applicable, use
a cylinder base for added stability. Do not weld or otherwise
modify the cylinder to attach a base or other support.
Avoid situations where loads are not directly centered
on the cylinder plunger. Off -center loads produce
considerable strain on cylinders and plungers. In
addition, the load may slip or fall, causing potentially dangerous
results.
Distribute the load evenly across the entire saddle
surface. Always use a saddle to protect the plunger.
IMPORTANT: Hydraulic equipment must only be serviced
by a qualifi ed hydraulic technician. For repair service,
contact the Authorized ENERPAC Service Center in your
area. To protect your warranty, use only ENERPAC oil.
WARNING: Immediately replace worn or damaged parts
with genuine ENERPAC parts. Standard grade parts will
break causing personal injury and property damage.
ENERPAC parts are designed to fi t properly and withstand high
loads.
2.1 Battery Operated Pump Safety
WARNING: Failure to observe the following precautions
may result in serious personal injury or death!
• Do not operate the pump in explosive atmospheres, such as in
the presence of fl ammable liquids, gases, or dust. The pump
creates sparks which may ignite the dust or fumes.
• Do not expose the pump to rain or wet conditions. Water
entering the pump will increase the risk of electric shock.
• Avoid accidental starting. Ensure the switch is in the
locked " " position before carrying or moving the pump. Do
not carry the pump with your hand or fi ngers on the trigger.
• Use safety equipment. Always wear eye protection. Safety
equipment such as dust mask, non-skid safety shoes, hard
hat, or hearing protection used for appropriate conditions will
reduce personal injuries.
• Do not use the pump if the switch does not turn it on and off .
Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
• Disconnect the battery pack from the pump before making any
adjustments, performing maintenance or storing the pump.
Such preventative safety measures reduce the risk of starting
the pump accidentally.
• Ensure the switch is in the locked position before inserting
battery pack. Inserting the battery pack onto the pump with
the switch on invites accidents.
• Recharge only with the charger specifi ed by the manufacturer.
A charger that is suitable for one type of battery pack may
create a risk of fi re when used with another battery pack.
• Use the Enerpac BP1 Series pump only with MILWAUKEE
V28 ™ Li-Ion battery packs. Use of any other battery packs may
create a risk of injury and fi re.
• When battery pack is not in use, keep it away from other metal
objects like paper clips, coins, keys, nails, screws, or other
small metal objects that can make a connection from one
terminal to another. Shorting the battery terminals together
may cause burns or a fi re.
• Under abusive conditions, liquid may be ejected from the
battery. Avoid contact. If contact accidentally occurs, fl ush
with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or
burns.
2