Functioning; Operation; Setting Up The Product; Replacing The Rechargeable Battery - LIVARNOLUX HG02014A Montage-, Bedienungs- Und Sicherheitshinweise

Remove the batteries / rechargeable batteries if the product will
not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery / rechargeable battery!
When inserting ensure the correct polarity! This is shown inside
the battery compartment!
Clean the contacts on the battery and in the battery compart-
ment before inserting!
Remove exhausted batteries / rechargeable batteries from the
product immediately.

Functioning

The solar cell
1
trical energy and stores it in one rechargeable battery. Switch on
the product with the ON / OFF button
tically light on as it begins to get dark. The in-built light-emitting di-
odes are a very long-life and energy-saving light source. The light
duration depends on the amount of sunlight, the angle of light on
the solar cell and the temperature (the battery capacity is tempera-
ture-dependent). A vertical angle of light at temperatures above
the freezing point is ideal. The battery does not achieve maximum
capacity until after several charge and discharge cycles.
In summer a completely drained rechargeable battery takes about
2 to 4 days to fully recharge in constant sunlight.

Operation

1. Press the ON / OFF button
on during darkness.
2. Your product is ready for use.

Setting up the product

In order to achieve the best result, set the product up in a
place where the solar cell
long as possible.
Make sure that the solar cell
source of light such as yard or street lighting as otherwise the
light will not come on in twilight.
The light automatically switches on in twilight conditions and
off again when normal outdoor lighting conditions return.

Replacing the rechargeable battery

(see Fig. A + B)
The battery should be replaced every 12 months to ensure
optimum performance.
1. Turn the product upside down. Press the ON / OFF button
to switch off the product. Loosen the fastening screws
using a small cross head screwdriver and then lever out the
battery compartment lid
2. Take out the silicone cover
3. Exchange the old rechargeable battery
Take care to the correct polarity, when inserting the new re-
chargeable battery. The polarity is indicated in the battery
compartment
the same technical data like the old one.
4. Put back the silicone cover
5. Now again fasten the battery compartment lid
fastening screws
26 GB/MT
installed in the product converts sunlight into elec-
5
1
with the help of a slot screwdriver.
6
9
. The new rechargeable battery has to have
8
9
by using a small cross head screwdriver.
4
. The product will automa-
5
to enable the product switching
will get direct sunlight for as
is not influenced by any other
1
(for model C only).
to a new one.
7
(for model C only).
5
by
4
, fasten the
6