Maintenance Frequency Indicator - elco CB-P2.170 G-U/TCG KN Betriebsanleitung

Maintenance

Maintenance frequency indicator

A4 Display
BP1 push-button 1
Request: fault code
BP2 push-button 2
Request: values
After a certain period of operation, the
following information may be displayed:
This means that
maintenance must be
carried out by a
specialist.
If the fitter has
registered his
telephone number,
then this appears,
as well as the number
of the completed
service contract
(accessible via the
fault menu).
To change the telephone number
• Call up the fault menu by pressing BP1,
then keep pressing the button to scroll
through BP1 until the desired pictogram is
displayed.
• Press BP2 to enter a change in the
pictogram: the first figure flashes.
• Select the value (from 0 to 9) by repeatedly
pressing BP1.
• Confirm by pressing BP2.
• Repeat the operation until you reach the
last figure. After confirming the last figure,
the complete pictogram is displayed for 5
seconds, then the control unit returns to the
operating screen.
To change the contract number
• Call up the fault menu by pressing BP1,
then keep pressing the button to scroll
through until the desired pictogram
«contract number» is displayed.
• Press BP2 to enter a change in the
pictogram: the first figure flashes.
• Select the value (from 0 to 9) by repeatedly
pressing BP1.
• Confirm by pressing BP2.
• Repeat the operation until you reach the
last figure.
After confirming the last figure, the complete
pictogram is displayed for 5 seconds, then
the control unit returns to the operating
screen.
05/2014 - Art. Nr. 420010540302
en
81