Using The Appliance - Philips SC2000 Bedienungsanleitung

Note: This table shows the number of flashes the appliance can give at each
light intensity and the corresponding expected efficacy. Please use the intensity
appropriate for your skin colour and body hair colour.

using the appliance

The light intensity you use can feel warm or hot on the skin, but should
never feel uncomfortable.
This appliance is only intended for removing women's body hair on areas
below the neck: underarms, bikini area and legs.
Note: Shave the area you intend to treat before you use the appliance (see
chapter 'Preparing for use').
Tip: The best time for treatment is before you go to bed at night.This
diminishes any skin reaction that may occur overnight.
1 Press the on/off button to switch on the appliance.
Intensity light 1 goes on automatically to indicate that the appliance
,
is switched on at default intensity 1.
Note: You can switch off the appliance any time by pressing the on/off button
again.
Note: It is normal that the appliance becomes warm during use.
 Press the % button to increase the intensity. To lower the intensity,
press the ^ button.
Every time you press the button, the corresponding intensity
,
light starts to flash. This takes a few seconds.
 Place the appliance perpendicularly on the skin so that the
removable window and the safety ring are in contact with the skin.
Tip: When you use the appliance for the first time, try it out, for instance on
your hip, to get accustomed to the light-based method. Start with the lowest
recommended intensity and increase it until you have reached the highest
recommended intensity. This test tells you how sensitive your skin is to light.
Check if your skin shows any reactions 20 minutes after the test. If it does, use
a lower recommended intensity for the areas to be treated.
EngliSh
1