Mounting Steps - Lenze E84AZESR5524LD Montageanleitung

5.1.2

Mounting steps

Proceed as follows for installation:
1. Prepare M5 threaded holes on the mounting plate and equip them with
screws and washers.
–
Use four M5 screw and washer assemblies or M5 hexagon socket
screws with washers.
–
Do not yet tighten the screws.
2. Mount the filter onto the prepared mounting plate.
–
Only tighten the screws hand-tight.
3. Loosen the two screw and washer assemblies to fix the standard device
on the filter.
–
Two M5 × 14 mm screw and washer assemblies.
4. Mount the standard device onto the filter and tighten the screws.
–
Observe the instructions in the documentation for the standard device.
–
Tightening torque: 3.4 Nm (30 lb-in)
5. If necessary, preassemble additional units.
6. Align all units.
7. Screw all units onto the mounting plate.
–
Tightening torque: 3.4 Nm (30 lb-in)
EDK84ZESR55 DE/EN/FR/ES/IT 2.0
Mechanical installation

Standard mounting
Mounting steps
5
E84ZESR020
39