Connecting The Water Hose To The Refrigerator; Connecting Of The Water Hose To The Cold Water Mains Line - Beko GNE134751X Handbuch

Installation
Check that following parts have been delivered
together with the product:
1. Union for connecting the water hose to the rear
of the refrigerator
2. 3 pieces of pipe clips (used to secure the water
hose)
3. 5-meter long water hose (1/4 inch in diameter)
4. Cold mains water valve with mesh filter (tap
adapter)
5. External water filter. (If there is a demijohn
connection; it is not necessary to use a water
filter.)
1 2
3 4
3.8 Connecting the water
hose to the refrigerator
1. Slip the union (b) onto the water hose (a).
2. Push the water hose downwards firmly to slip it
onto the water inlet valve (c).
3. Tighten the union (c) by hand to secure it onto
the water inlet valve.
Refrigerator / User Manual
*5
a
a
b
2
1
c
9 / 32 EN
C
Normally, you are not required to tighten
the union with a tool. However, you can use
a spanner or pliers to tighten the union if
there is a leakage.
3.9 Connecting of the water hose
to the cold water mains line
(in some models)
If you will use the refrigerator by connecting it
to the cold water mains line, you must install a
standard 1/2" valve connector to the cold water
installation of your home. If this valve is not present
or you are not sure, consult a qualified plumber.
1. Separate the union from the tap adaptor.
2. Install the tap adaptor to standard 1/2" valve
connector.
3. After inserting the water hose to the union,
install it to the tap adaptor and insert to the
union to the tap adapter.
4. Tighten the union by hand.
A
WARNING:
to suitable points by means of the
clips supplied to avoid any damage or
displacement or accidental disconnection.
A
WARNING:
valve, make sure that there is no leakage
at both connection points of the water
hose. If there is a leakage, turn off the
valve immediately and tighten all joints
again using a spanner or a pliers.
A
WARNING:
valve connector is available and completely
turned off on your cold water mains line.
Secure the water hose
After turning on the water
Make sure that standard 1/2"