Screen Size Selection; Changing The Screen Size - Pioneer PDP-502MXE Bedienungsanleitung

Screen size selection
Changing the screen size
The size of the picture or the picture's range projected on
the screen can be changed between 4 screen sizes
described in the table on this page.
Press SCREEN SIZE to select the size.
The screen size changes each time SCREEN SIZE on the
remote control, or SIZE on the unit is pressed as follows.
For PC signals
[_ OR,GINAL , 4:3 NORMAL "_1
ZOOM _- FULL
(For screen sizes when the video signal of a personal
computer is input, please see Supplement 1 on page 26.)
Moving the screen position
upward or downward
During personal computer input (1280 x 1024/60Hz only),
when the ZOOM setting is selected, the position of the
screen can be adjusted by using A/v.
0_,ORIGINAL
The input signal and the screen maintain a dot to line ratio
of 1:1 and is thus highly faithful to the source.
480 lines
768 lines
dots
1280 dots
(Illustration shows 640 x 480 input.)
,2.4:3 NORMAL
The display fills the screen as much as possible without
altering the aspect ratio of the input signal.
IAI
.3.,FULL
The display is presented with a widescreen aspect ratio
of 16:9 and fills the entire screen.
A
@ ZOOM
The ZOOM setting is available only during personal
computer input (1280 x 1024/60 Hz only).
The input signal and the screen maintain a dot to line ratio
of 1:1. Display is highly faithful to the source. However, in
order to maintain the 1:1 ratio, a )ortion of the display will
not appear on the screen.
768 lines
1024 lines
Use A/v to adjust the position of the video image on the
screen.
16
Erl