Original Ancillaries / And Accessories; Switching On And Off; Setting The Oscillation Speed; Attaching A Sanding Sheet - Parkside PSS 250 A1 Originalbetriebsanleitung

General safety advice for electrical power tools / Operation
J
The appliance must always be kept
clean, dry and free of oil or lubricat-
ing greases.
Original ancillaries / and
Q
accessories
J
Only use accessories and tools that
are specified in the operating instruc-
tions. The use of tools and accessories other
than those recommended in the operating
instructions could lead to an increased risk of
personal injury for you.
Operation
Q

Switching On and Off

Q
Switching on intermittent function:
j
Press the ON / OFF switch
Switching off intermittent function:
j
Release the ON / OFF switch
Switching on continuous operation :
j
Press the ON / OFF switch
and press the locking button
Switching off continuous operation:
j
Press the ON / OFF switch
again.

Setting the oscillation speed

Q
You can set the desired oscillation speed as
needed with the oscillation speed selector
The required oscillation speed depends on the ma-
terial being worked and can be determined through
practical tests.

Attaching a sanding sheet

Q
WArNING!
Before performing work on the
appliance, always disconnect the power.
10 GB
NOTE: Before attaching a new sanding sheet
remove dust and dirt from the sanding plate
Sanding sheets with hook and loop
fastening:
j
j
Sanding sheets without hook and loop
fastening:
j
j
j
Various materials require different grit values. You
can read which grit value is best suited for which
work in our recommendations under "Instructions, tips
1
.
and tricks".
1
.
Q
, hold it pressed
1
2
.
collection box
then release it cleaner via an external suction adapter! Under cer-
1
tain conditions the sanding dust in the dust box (or
in the vacuum's dust bag) may self-ignite, e.g. as
a result of flying sparks generated when abrading
metals or metal objects left in wood. This can hap-
pen especially if the wood dust has paint particles
on it or is mixed with other chemical substances
. and the sanded material is hot after extensive
10
working. You should therefore avoid overheating
of products being sanded as well as the appliance
and always empty the dust collection box
the dust bag of the vacuum cleaner before work
pauses.
Fix one side of the sanding sheet
one side of the backing plate
Then attach the sanding sheet
ing plate and press it firmly into place.
8
Open the two clamping levers
Push one end of the sanding sheet
the open clamping bar
sheet firmly in place by locking the clamping
lever back in place.
7
Repeat this procedure at the other end.

Vacuuming dust

WArNING!
A risk of fire exists when working with
electrical appliances that have a dust
or can be attached to a vacuum
4
Wear a dust mask!
,
9
.
8
flush with
9
.
8
to the back-
9
.
7
under
9
and clamp the
6
FIrE HAzArD!
or
4