Care And Cleaning - Sharp Plasmacluster SJ-F750SP Bedienungsanleitung

CARE AND CLEANING

WARNING
Unplug the refrigerator first to prevent electric
■
shock.
Do not splash water directly on the outer cabinet
■
or the interior. This may lead to rusting and
deterioration of the electrical insulation.
IMPORTANT
To prevent cracking on inside surfaces and plastic
components, follow these tips.
• Wipe any food oils adhered to plastic components.
• Some household chemicals may cause damage, so use
only diluted washing-up liquid (soapy water).
• If undiluted detergent is used or soapy water is not wiped
off thoroughly, cracking of plastic parts can result.
1
Remove the shelves and pockets from the cabinet and
door. Wash them in warm soapy dishwashing water;
rinse in clean water and dry.
2
Clean the inside with a cloth soaked in warm soapy
dishwashing water. Then, use cold water to wipe off
soapy water.
3
Wipe the exterior with a soft cloth each time it is soiled.
4
Clean the Magnetic door seal with a toothbrush and
warm soapy dishwashing water.
5
Wipe the control panel with the dry cloth.
WHAT TO DO BEFORE YOU CALL FOR SERVICE
Before you call for service, check the following points.
Problem
The outside of a cabinet is hot when
touched.
When there is refrigerator noise.
Frosting or dew generation occurs
inside or outside the refrigerator.
The foods in the refrigerator
compartment freeze.
It smells in the compartment.
IF YOU STILL REQUIRE SERVICE
Refer to your nearest service agent approved by SHARP.
10
NOTE
•
To prevent damage to your refrigerator, do not use heavy
duty cleansers or solvents (lacquer, paint, polishing powder,
benzine, boiled water, etc.).
• If the power supply is disconnected, please wait for at least
5 minutes before re-connecting power.
•
The glass shelves weigh approximately 3 kg each. Hold
firmly when removing from the cabinet or carrying.
• When dropped the juice and the like near the control panel,
wipe off directly. It becomes cause of failure of the control
panel.
• Do not drop objects inside the refrigerator or strike the inner
wall. This may cause the inner surface to crack.
When the compartment light is blown
Contact the service agent approved by SHARP to request
a replacement compartment light. The compartment light
is not to be removed other than by qualified service
personnel.
Switching off your refrigerator
If you switch your refrigerator off when you are going away
for an extended period, remove all food, clean the interior
thoroughly. Remove the power cord plug from the power
socket and leave all doors open.
It is normal. The hot pipe is in the cabinet in order to prevent dew generation.
It is normal for the refrigerator to produce the following sounds.
• Loud noise produced by the compressor when operation starts
--- Sound becomes quieter after a while.
• Loud noise produced once a day by the compressor
--- Operating sound produced immediately after automatic defrost
operation.
• Sound of flowing fluid (gurgling sound, fizzing sound)
--- Sound of refrigerant flowing in pipes (sound may become louder from
time to time).
• Cracking or crunching sound, squeaking sound
--- Sound produced by expansion and contraction of inner walls and internal
parts during cooling.
This may occur in one of the following cases. Use a wet cloth for wiping frost
and a dry cloth for wiping dew.
• When the ambient humidity is high.
• When the door is frequently opened and closed.
• When foods containing plenty of moisture are stored. (Wrapping is required.)
• Is the refrigerator operated for a long time with refrigerator temp. control set
at 0°C?
• Is the refrigerator operated for a long time with freezer temp. control set at
-21°C?
• Low ambient temperature may cause placed foods to freeze even if
refrigerator temp. control is set to 6°C.
• Wrapping is required for the foods with strong smell.
• Deodorizing unit cannot remove all of smell.
Solution