Coffee Dispensing; Other Hot Beverage - Faema SMART Gebrauch Und Installation

13. Coffee dispensing

(10), empty out any coffee grouts
grinder/doser presser.
unit, positioning the cup (or cups) under the nozzle (or
Press the coffee dispensing push button (16, 17, 19, 20) for
Press the push button (21) for continuous dispensing.
Dispensing, whether for dosed servings or in the continuous
dispensing mode, can be interrupted at any time by
pressing the STOP push button (18).

14. Other hot beverage

Danger of Burns! Use the appropriate
insulating devices (A) to move the water and
steam nozzles.
Steam dispensing
Completely immerse the right or left steam nozzle (6) into
the container with the liquid to be heated and push the
steam control lever (7) upwards.
Wait until the liquid has reached the desired temperature,
then lower the steam command lever (7) to stop the issue
of steam.
Cleaning of steam nozzles
At the conclusion of each steam dispensing
phase:
- Using a clean sponge, wash with hot water
removing any organic residue present. Rinse
carefully.
- clean the inside of the steam nozzle as
follows: turn the nozzle towards the cup tray
and carefully activate steam dispensing at
least once.
Heating milk for frothy coffee (cappuccino)
General indications
Milk is a delicate biological product and can easily
at a storage temperature no higher than 5°C (41°F) from
the moment the container is opened and throughout its
entire period of use. Our storage appliances are suitable
for this purpose.
NOTE: at the end of the work day (or not more than 24
hours from the time the container is opened), any remaining
milk must be discarded.
10) on the coffee dispenser
10).
coffee dispensing has completed.
7
A
6
Then plunge the steam jet pipe (6) into the milk.
Gradually open up the steam tap (7) and heat the milk for
a few seconds.
When the required amount of froth has been made and the
turning knob (7) the other way (towards "0").
When the steam jet pipe (6) is no longer required, clean it
thoroughly with a sponge and a clean cloth.
Dispensing hot water
Put a cup or other container under the hot water spout (8).
Lift lever (9) to dispense the desired amount of hot water.
Stop the dispensing by put lever (9) back into its original
position.
12 EN
16 21 17
19
20
18
10
9
8
A