Storage; Troubleshooting; Disposal - Zipper ZI-BTS350 Betriebsanleitung

17.2.2 Storage

If the machine more than a month is not used, please follow these instructions:
 Entire remove fuel from the tank, fuel cock and carburetor.
 Water from the tap and remove line (this is to do in cold weather after each use)
 Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole
 Engine switch to the OFF
 Operate starter rope several times
 Spark plug insert
 Generator in a dry, well ventilated place, cover.

18 TROUBLESHOOTING

Trouble
Engine will not start
Motor stoppt kurz
nach Start wieder
Motorleistung zu
gering
Trennscheibe dreht
sich nicht
Trennscheibe eiert
18.1

Disposal

Do not dispose of your waste in the ZI-BTS350. Contact your local
authorities for information regarding the available disposal options.
Improper disposal can lead to contamination of soil, ground water soil
seepage of hazardous and noxious substances, and thus reach finally
through contaminated water into your food supply and your health
you gefährden.Wenn replace your old unit with a new one at your
local dealer, is obligated to take back your old equipment free of
charge for the purpose of proper disposal.
Z.I.P.P.E.R Maschinen Austria  www.Zipper-maschinen.at
Betontrennschneider / Concrete cutter ZI-BTS350
Possible Cause
 ON OFF switch to OFF
 Fuel filter clogged
 Great power tank empty
 Spark plug is defective or loose
 Spark plug gap set wrong
 Idle speed too low
 Clogged fuel filter
 The fuel tank is empty
 Dirty air filter
 V-belt is defective
 defective clutch
 cutting wheel shaft
TROUBLESHOOTING
Solution
 Switch in the On position
 Fuel filter change
 Fill the fuel tank
 Clean or replace spark plug

Check the correct setting
 Adjust idle speed
 Change the fuel filter
 add fuel
Clean or replace air filter

 Change belts
 machine repair
 Check ball bearings, shaft,
nut.
 Replace if defective
flange and
Seite 29