Setting Up And Connecting; Disposal Of The Packaging; Requirements On The Installation Location - Silvercrest SLB 450 A1 Bedienungsanleitung

Disposal of the packaging

GB
MT

Requirements on the Installation Location

68
The packaging protects the appliance from transport damage. The packaging
materials are selected from the point of view of their environmental friendliness
and disposal technology and are therefore recyclable.
The recirculation of packaging into the material circuit saves on raw material
and reduces generated waste. Dispose of packaging material that is no longer
needed according to the regionally established regulations.
NOTICE
► If possible preserve the appliance's original packaging during the warranty
period so that in the case of a warranty claim you can package the appliance
properly for return.
DANGER
Risk of fatal electrocution!
Should the appliance make contact with water whilst connected
to the mains power supply there exists a potentially fatal risk!
Observe the following safety notices to avoid electrical hazards:
► All parts containing electrical components, except remote control devices,
should be located or secured so that they cannot fall into the bathtub.
► Parts that are charged with standard mains power, i.e. all parts except those
supplied with the extra low safety voltage of up to 12 V, MUST be inacces-
sible to people in the bath.
For a safe and error-free operation of the appliance, installation location must
fulfi ll the following conditions:
■ Never place the pump above the bathtub.
■ Place the pump on a fi rm, level and dry surface.
■ Place the pump in such a way that the suction opening under of the pump
housing cannot be covered (such as by a bath mat).
■ Do not place the pump in a wet environment or in a spraywater area.
■ Do not place the pump directly next to a radiator or a radiant heater.
■ The mains power socket must be protected by an FC protector switch
(RCD) with a rated residual current not exceeding 30 mA.. It must be easily
accessible, so that the plug can be quickly removed in an emergency.
■ Secure the air-bubble mat to the fl oor of your bathtub with the rear suction cups.

Setting up and connecting

SLB 450 A1