NEC NP01SW serie Installationsanleitung Seite 13

Connection terminal section (inputs)

HDMI1 input terminal
①
Connect this to the HDMI output terminal of
a computer or image device.
HDMI2 input terminal
②
Connect this to the HDMI output terminal of
a computer or image device.
HDMI3/MHL input terminal
③
Connect this to the HDMI output terminal of
a computer or image device. Or connect a
device that supports the MHL standard.
MIC input terminal
④
Connect a microphone.
USB-A port
⑤
(This can be used when the receiver box is
connected.)
Connect a USB memory device here when
using mainly the projector's VIEWER func-
tion.
USB-B port
⑥
(This can be used when the receiver box is
connected.)
Connect this to the computer's USB-A port
when using mainly the projector's Interac-
tive White Board Kit or USB Display func-
tion.
  
⑦
⑧
ENG-11
  
LAN port
(This cannot be used when the receiver box
is connected.)
Connect this to the computer's LAN port.
Use this to control the projector or display
from the computer.
SERVICE terminal
This terminal is for service purpose only. (Not
available for users)
NOTE
• On the interface selector, the USB-A and
USB-B ports cannot be used simultane-
ously. Selection either the USB-A or USB-
B port can be performed by the selector
switch on the receiver box (see
following page).

on the
⑥