Operation - Worx WG630E Bedienungsanleitung

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
INTENDED USE
This tool is intended for cleaning and watering.
ASSEMBLY & OPERATION
BEFORE OPERATION
Installing the battery pack
Removing the battery pack
Checking the battery condition
NOTE: Fig. A3 only applies for the battery pack with battery indicator light.
Charging the battery pack
More details can be found in charger's manual
ASSEMBLY
NOTE: The power nozzle has two working modes: short lance only and
short lance used together with extension lance.
Working mode 1
Attaching short lance to the power nozzle
NOTE: When attaching, align the two projections on the lance with the grooves of the
power nozzle as shown in Fig. B.
Attaching the Multi-spray nozzle
NOTE: When attaching, rotate the nozzle left and right to make sure the nozzle is fully
seated into position and gently pull it to make sure it is locked into position securely.
16
Attaching the hose to the power nozzle
NOTE: After the hose is attached, check the connection by gently pulling upon the hose. It
should not be pulled off.

OPERATION

WARNING: The supplied battery is not waterproof. To avoid risk of battery
failure,
protect the battery from water exposure during use. Store the tool and battery in
a dry place after use.
Start
NOTE: At the first use, you need to empty the air in hose, place the
power nozzle below waist level (<1.5m/5ft) and set it at high pressure.
Do not start working until the water goes up along the hose and
sprays out. This could take up to 30 seconds or more depending on
the fresh water source.
Selecting the nozzle pattern
NOTE: Choose a suitable nozzle pattern according to your work. Spray
patterns 0 , 15 , 25
o o
pattern with the symbol
WARNING: Do not shift the nozzle pattern when the tool is powered on.
Cleaning
WARNING: Do not connect the machine to water supplies that are dirty,
rusty, muddy, or corrosive. (Including window cleaning liquids, plant foods,
or fertilizers etc.)
NOTE: If sea water is used, the product should be rinsed and used with fresh water after
that in order to extend the life time of the machine.
Watering
2 in 1: Portable Power
Cleaner/Water Sprayer
ACTION
and 40 are applicable for cleaning, and the spray
o o
is best suitable for watering.
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. A4, A5
See Fig. B
See Fig. C
See Fig. D1,
D2, D3
See Fig. E
See Fig. F
See Fig. G, H
See Fig. I
EN