Installation; Operation - HQ Power VDPLP64B4RGB Bedienungsanleitung

• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.

4. Installation

a) Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5 m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
b) Fuse Replacement
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating:
1. Remove the fuse holder using an appropriate screwdriver.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.

5. Operation

• Stand-Alone Mode
In stand-alone mode, you can use the PAR64 without a controller.
o Automatic Mode
The VDPLP64B4RGB features pre-programmed effects. Select them as follows:
1. Press MENU until
2. Confirm your selection with ENTER.
3. Select the desired effect (
4. Confirm your selection with ENTER.
o Sound-Active Mode
The VDPLP64B4RGB features sound-triggered effects. Select them as follows:
1. Press MENU until
2. Confirm your selection with ENTER.
3. Select the desired effect (
4. Confirm your selection with ENTER.
5. Adjust the microphone sensitivity with the sensitivity adjustment knob [5].
o Preset Colour Mode
The VDPLP64B4RGB features static colour effects. Select them as follows:
1. Press MENU until
2. Confirm your selection with ENTER.
3. Select the desired colour (
4. Confirm your selection with ENTER.
29.03.2011
VDPLP64B4RGB
appears on the LCD control panel.
, see below) with the UP or DOWN button.
appears on the LCD control panel.
, see below) with the UP or DOWN button.
appears on the LCD control panel.
, see below) with the UP or DOWN button.
4
Rev. 02
©Velleman nv