Product Overview; X1000; Top; Back - Cisco Linksys X-Series Benutzerhandbuch

Linksys X-Series

Product Overview

X1000

Top

Ethernet—If the LED is continuously lit, the modem router is
successfully connected to a device through that port.
Wi-Fi Protected Setup™—The LED is continuously lit when a Wi-Fi
Protected Setup™ connection is successfully established. The LED
blinks slowly while Wi-Fi Protected Setup™ is setting up a connection,
and blinks rapidly if an error occurs. The LED is off when Wi-Fi Protected
Setup™ is idle.
Wireless—Lights up when the wireless feature is enabled. It flashes
when the modem router is actively sending or receiving data over the
network.
WAN—Lights up green when the modem router is connected directly
to an ADSL line. Lights up blue when the modem router is set up as
a router only and is connected to the internet through a separate
modem.
Internet— Lights up green when the modem router has an Internet
connection. Flashes green while the modem router is establishing the
Internet connection. Lights up red when the modem router cannot
obtain an IP address.
Power—Lights up green when the modem router is powered on.
When the modem router goes through its self-diagnostic mode during
every boot-up, the LED flashes. When the diagnostic is complete, the
LED is continuously lit. Lights up red when an error occurs.

Back

DSL port—Connects to the ADSL line.
Cable port—To use the modem router as only a router, use
a network cable to connect this port to a separate modem's
LAN/Ethernet port.
Ethernet port—Using Ethernet cables (also called network
cables), these Ethernet ports connect the modem router
to computers and other Ethernet network devices on your
wired network.
Wi-Fi Protected Setup™ button—Press this button to
have Wi-Fi Protected Setup™ search for your Wi-Fi Protected
Setup™-supported wireless device.
Reset button—This button allows you to reset the router
to its factory defaults. Press and hold the Reset button for
about five seconds.
Power port—The Power port connects to the included
power adapter.
Power button—Press | (on) to turn on the modem router.
Product Overview
1 1