Troubleshooting; Presentation - Sony VPL-PX15 Bedienungsanleitung

Troubleshooting

Setting/Connecting
Symptom
A connection to the network is not
established.
The computer cannot access to the
projector.

Presentation

Symptom
Fonts or styles change in a PowerPoint,
Excel or Word file.
If the projector appears to be operating erratically, try to diagnose and
correct the problem, using the following guide. If the problem still persists,
consult with qualified Sony personnel.
Causes and remedies
• The PC card is not properly inserted into the PC CARD slot.
t Check that the card is facing correctly, then push the card into the slot until it
is firmly seated.
• The cable is not properly connected to the ETHER connector.
t Insert the plug of the cable to the connector firmly.
• The wireless LAN PC card and wireless LAN access point you are using are not
the specified/recommended ones.
t Use the specified/recommended devices. Use of those not specified/
recommended may cause incorrect operation.
For information on the specified/recommended cards, etc., see the attached
"Specified/recommended PC Card."
• The network environment is not properly set up.
t Check the network configuration settings of the projector.
(pages 10 (GB) - 12 (GB))
t When you control the projector by using the computer's Web browser, check
the network settings on the computer as well.
• When you use a wireless LAN PC card (VAIO/ORiNOCO), Enable is selected.
t Select Disable. (page 10 (GB)).
• When you are using the wireless LAN PC card, the wireless LAN is not properly
set up.
t Check that the Access Point ID and Encryption Key in the Connecting
Status dialog box are set to the same numbers as those of the connected
access point (page 11 (GB)).
• When you are using the wireless LAN PC card, Peer to Peer mode is not
properly set up.
t Select Peer to Peer only on a piece of equipment connected to the same
wireless LAN (page 12 (GB)).
• The channel of the access point is set to 12–14.
t Set the channel of the access point to 1–11.
• The wireless LAN PC card, memory card or access point still does not operate
properly after checking the above.
t Consult with the manufacturer of the card or access point you use. When
you are using the specified Sony wireless LAN PC card, consult with the
qualified Sony personnel.
• The setting of INPUT-B FUNC. (VPL-PX15) or INPUT-C FUNC. (VPL-FX51) in
the INSTALL SETTING menu is not correct.
t Set it to ON.
• The browser of your computer is set to "Access the Internet using a proxy
server."
t Enter the IP address of the projector in the box "Access the Internet without
using a proxy server."
• You entered the projector's IP address started with 0 (zero).
t Do not enter 0 at the beggining of the number.
Example: 192.168.000.001 c192.168.0.1
Causes and remedies
In the text of the file, fonts or styles not supported by the Slide Viewer, Worksheet
Viewer or Document Viewer are used.
t Only the following fonts are available for the Slide Viewer. Other fonts will be
replaced with these fonts; Arial, Arial Black, Comic Sans MS, Courier New,
Georgia, Impact, Symbol, Tahoma, Times New Roman, Verdana, Wingdings. If
replaced, an end of paragraph may change according to tab or pharagraph
settings.
Styles not supported by the Slide Viewer will be replaced with supported styles.
(continued)
43
(GB)