Optika B-1000 Serie Bedienungsanleitung Seite 7

Insert the optical head above
the Bertrand lens, using the
other 3mm Allen wrench to
tighten the screw. (Fig.2)
Insert both eyepieces into
the tubes of the optical head.
(Fig.3)
Insert the condenser under
the stage: position until it is
well inserted into its holder
(under the condenser there is
a pin that must fully enter the
guide of the holder). (Fig. 4)
Mount the rotating stage: at
the bottom of the stage there
is a spring, push this spring
toward the stage support
then push the stage
downward (Fig.5)
②.
,
①
SPRING
①
Page 7
Fig.2
Fig.3
AFTER INSERTING THE
CONDENSER, TIGHTEN
THIS SCREW
Fig.4
②
Fig.5