Caliber HCG 008Q Bedienungsanleitung Seite 2

SPECIFICATIONS, CONNECTIONS AND BUTTONS
Input:
Power Consumption:
Frequency range:
Speaker:
Backup battery
(for clock memory)
Dimensions:
We are continuously improving/updating our products and product information.
It's therefore possible that there is a slight difference between the description in this manual to the operation of the product.
If something is different or not clear; always check our website for the most current version.
1. Mode / Standby q button
Push repeatedly to switch between:
FM radio / Line in (AUX) / OFF (standby)
2. Alarm / Sleep button
- In Standby: Push to enter alarm settings
- In FM/LINE: Hold to set sleeptimer
3. Set / Mem button
- In Standby: Push to enter clock settings
- In FM: Hold to enter preset memory storage
4. Snooze / Dimmer button
- When alarm sounds: push to snooze for 9 min.
- In Standby: push to switch between LED
brightness or hold 3 sec. to switch LED OFF.
To turn LED back ON, hold for 3 sec. again.
When the LED display is switched OFF you can
push any button to light up the screen for 10 sec.
5. Vol button
- In FM/LINE: push and use DOWN/UP to set
6. Down button
- In FM: tune down
7. Up button
- In FM: tune up
8. Qi (Wireless charging) surface
Location to place a device suitable for wireless
charging*
9. Speakers
10. Alarm 1 indicator
Indication LED if Alarm 1 is active
11. Alarm 2 indicator
Indication LED if Alarm 2 is active
12. PM indicator
Indication LED for PM time (only in 12HR mode)
100~240V / 50Hz
3W
FM 87.5 - 108MHz
8Ω 0.3W
: 2x 1,5V
(AAA)
218(W) x 88(D) x 94(H)mm
13. Qi Wireless Charging indicator
14. Clock display
15. FM indicator
16. Aux indicator
17. Sleep indicator
18. FM antenna
19. AUX-in (Line-in) jack input
20. USB charge slot
21. DC 5V power input
22. Battery compartment (2x AAA 1,5V)
* Self adhesive rubber ring included. To be stuck on the
charge surface for anti-slip (optional)
- not included
Indication LED for if wireless charging is active
Indication LED for FM mode (for alarm settings)
Indication LED for AUX mode (for alarm settings)
Indication LED for if sleeptimer is active
3.5mm Jack input to connect an external device
Standard USB slot with 5V output for charging
DC input for provided adapter
Place batteries for memory preservation for a
short period of time (optinonal)