Items Supplied; How To Use; Before Using For The First Time; Operation - Silvercrest STK 600 A1 Bedienungsanleitung

__RP90246_B5.book Seite 35 Mittwoch, 27. März 2013 11:20 11
soften the silicon feet. If necessary,
place a non-slip mat under the device.
• Only use the device in conjunction with
the base station supplied.
• None of the parts are suitable for use
in microwave ovens.
• Never put alcohol, sugar or milk into
the glass pot!
• Always allow the glass pot to cool be-
fore filling it with cold water. Large tem-
perature differences create large
stresses in the glass and may cause it to
shatter.
• Place the device on a stable, flat surface.
• Only use the original accessories.
• Do not use any astringent or abrasive
cleaning agents.

3. Items supplied

1 tea kettle
1 cleaning brush|16
1 set of operating instructions

4. How to use

DANGER of electric shock!
Only connect the device to an easily
accessible wall socket whose voltage
corresponds to the specifications on
the rating label. The wall socket must
continue to be easily accessible after
the device is plugged in.
• Pull the mains plug|15 out from the wall
socket after every use.
• Remove all packaging material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Place the device on a stable, flat surface.
1. Ensure that the On / Off switch|11 is
set to O.
2. Insert the mains plug|15 into a wall sock-
et corresponding to the technical data.
5. Before using for the
first time
1. Carefully rinse out all parts of the boil-
ing system|5 and the glass pot|8 (see
"Cleaning" on page 37).
2. Remove the boiling system and fill the
glass pot|8 with water to the MAX
marking|9.
3. Add a teaspoon of lemon juice or lemon
concentrate to the water. If this is not avail-
able, you can add a teaspoon of loose tea
directly into the water.
4. Insert the boiling system|5 into the glass
pot|8.
5. Close the lid|6 and place the glass pot|8
on the base|14.
6. Use the On / Off switch|11 to switch
the device on (I). The control light|12
and the On / Off switch will light up.
Wait until the control light goes out.
7. Use the On / Off switch|11 to switch the
device off (O) and clean the device (see
"Cleaning" on page 37).

6. Operation

DANGER of injuries through
scalding!
Do not bend over the glass pot|8
when you open the lid|6 and the
contents are still hot. There is a dan-
ger of being scalded by escaping
steam.
• The glass pot|8 and boiling system|5
become very hot during operation, you
should therefore protect your hands e.g.
using oven gloves.
• Keep the lid|6 of the glass pot|8 closed
during the boiling process, as otherwise
the automatic deactivation system will
not work and boiling water will spray
out.
• The glass pot|8 must not be filled with
water above the MAX marking|9, other-
35
GB