RS-RT3077 and the foam protection of the
motor (10b).
•
Separate
the
the
microfilter
Dispose of the microfilter in a dustbin and
replace it with a new microfilter Ref. RS-
RT3077.
•
Wash the foam protection of the motor
with warm, soapy water, rinse and leave
to dry for at least 12H before refitting it.
Once it is dry, place it on top of the
microfilter (10a).
•
Refit the Microfilter cartridge
compartment
(fig.
22).
•
Put the Wonderbag back into place
trouBlesHootiNg
IMPORTANT As soon as your vacuum
cleaner starts to malfunction, and before
performing any checks stop the appliance
by pressing the Start/Stop switch.
if your vacuum cleaner does not start
•
The appliance is not plugged-in, check that
the appliance is correctly plugged in.
if there is no suction
•
An accessory or the tube is clogged.
Unclog the accessory tube or flexible hose.
•
The cover was not closed properly: check
that the bag is properly installed and
reclose the cover.
if the suction of your vacuum cleaner has
dropped, it makes a noise and whistles
•
An accessory or the flexible hose is
partially clogged. Unclog the accessory
tube or flexible hose.
•
The bag is full or clogged with fine dust.
a new bag or empty the fabric dust bag.
•
The filter is full: change the HEPA* filter
cassette and fit it back into position (see
WArrANty
•
This product has been designed for
domestic use only. Any professional
use, innapropriate use or failure to
comply with the instructions, the
manufacturer accepts no responsibility
and the guarantee will not apply.
*Depending on model: this is either equipment specific to certain models or available as an optional accessory.
foam
(10b)
from
(10a)
(fig.
21).
(10b)
(10)
in its
(fig.
19).
Fit
Ensure that the Microfilter cartridge is
fitted correctly before closing the cover.
IMPORTANT Never operate the vacuum
cleaner without a filter cartridge. Your
appliance is equipped with a filter cartridge
presence safety system for this (the cover
will not close if a filter cartridge has not been
installed).
3 • Cleaning your vacuum
Clean the accessories of your appliance with
a soft damp cloth, then dry them. Do not use
abrasive or aggressive products.
page 16 paragraph 2).
•
If the manual suction regulator on the
grip is open, close the manual suction
regulator*.
if the bag full indicator remains red
•
The bag is full. Fit a new one.
if the floor nozzle is hard to move around
•
Set vacuum power with the 3-position
power control*
if the power cable does not rewind
completely
•
The power cord is slow in re-entering its
housing. Pull the cord out to its entire
length and press on the automatic cord
rewind pedal.
if problems persist, take your vacuum
cleaner to the nearest rowenta approved
service centre (see list of approved
service centres) or contact the rowenta
customer service (see contact details on
last page).
•
Read the instructions for use carefully
before using your appliance for the first
time: any use which does not conform to
these instructions will absolve Rowenta
from any liability.
17
gB