Bestron DTP800TP Bedienungsanleitung Seite 23

OPERATION - General
The appliance is intended
only for domestic use,
not for professional use.
1. Lid
2. Kettle
3. On/off switch
with pilot light
4. Base
5. Power cord with plug
6. Handle
OPERATION - Before use for the first time
When using the jug kettle for the first time, boil three jugs of water and dispose of the boiled water. This
will remove the last traces from the manufacturing process.
OPERATION - Boiling water
1. Turn the kettle so that the spout faces away from you.
2. Open the lid.
3. Fill the jug with the required quantity of water (at least 0.5 litres,
and a maximum of 0.8 litres). Never fill the water boiler over the
"max" indicator on the inside of the kettle (see figure 1). Otherwise
the hot water can spatter out of the spout. Make sure that you do
not spill any water.
4. Close the lid.
WARNING:
• Make sure the lid is locked while pouring water, otherwise it may
fall. To lock the lid, turn the lid a quarter after closing (see figure 2).
• The ceramic jug and spout become hot during usage, and stay
hot for a certain amount of time.
• Prevent high temperature differences: sudden replacement of
boiling water by cold water can cause cracks in the teapot.
5. Position the kettle on the base in such a way that the underside of
the kettle fits precisely into the
contact unit on the base.
6. Insert the plug in the wall socket. Push down the On/off switch. The
On/Off pilot light will illuminate.
7. The jug kettle is now switched on, and the water will now begin
to heat. The jug kettle switches off automatically a few seconds
after the water has come to the boil. The On/Off pilot light will now
extinguish.
8. Remove the jug by the handle, and pour the water out.
1
2
5
23
EN
6
3
4
1
2
1
2