Electrical Safety - BRICK MIX1623-2P Übersetzung Der Originalanleitung

repaired. Many accidents are caused by using
poorly maintained power tools.
Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to jam and are easier to control.
Use the power tool, accessories and cutting tools,
etc., in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work which needs to be done. Using a power
tool in ways for which it was not intended can lead
to potentially hazardous situations.
Service
Your power tool should be serviced by a qualified
specialist using only standard spare parts. This will
ensure that it meets the required safety standards.
as well as the additional safety instructions.
WARNING: Packaging materials
are not toys! Children must not
play with plastic bags! Danger of
In this manual and/or on the machine the following
symbols are used:
Read manual before use.
Always wear a dust mask.
In accordance with essential
applicable safety standards
suffocation!
Warning / Danger!
Wear ear protection.
Wear eye protection.
of European directives
Double insulated
ADDITIONAL SAFETY INSTRUCTIONS FOR USE
OF MIXERS
Firmly tighten the mixing paddle, and remove
the spanner before starting the machine.
Never mix or stir explosive or inflammable
substances.
When mixing, wear proper personal protection
measures for eyes, ears, hands and
breathing.
This appliance is not suitable for mixing
foodstuffs. The appliance cannot be adequately
cleaned in order to comply with hygiene regulations.
It is only possible to work safely with this tool if
you read these instructions for its use and
maintenance thoroughly and follow the instructions
meticulously.
Please also observe the other safely
instructions included in the delivery scope of every
tool.
Before using the tool, always check the flexible
supply lead and the plug. Any faults must
be repaired by an expert.
The tool must not be used in damp and wet
rooms, in the open in rain, fog, snow or in any
area in which there is a risk of explosion.
Before connecting the tool to the electricity
mains, make sure that it is switched off. Check
the position of the corresponding switch where
necessary.
Take care with long hair and fashion
accessories. Always wear close-fitting, properly
fastened clothing without any loose parts when
working with the tool.
Secure the container holding the substance
you wish to mix on the floor to prevent it
moving.
Always guide the flexible supply lead to the
back away from the tool. Do not exert any
strain on the flexible lead by pulling it, and make
sure that it is not lying on or guided over
any sharp edges.
Take care when working that you are standing
in a safe and secure position.
Always use the additional handle.
Expect there to be a torque reaction.

ELECTRICAL SAFETY

Before using the machine,
make certain that the mains
power supply corresponds to
the voltage stated on the
rating plate of the machine.
DESCRIPTION
1. ON/OFF switch
2. Release button for ON/OFF switch
3. Speed adjustment wheel
4. Gearbox ratio selector
5. Paddle holder
6. Mixer bar (mixer)
15