Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT:
always disconnect the appliance from the gas
and electricity mains before carrying out any
cleaning operation.
2) HOT PLATE
Periodically wash the hot plate, the enamelled stell
pan support, the enamelled burner caps "C" and
the burner heads "T" (see fig. 6) with lukewarm
soapy water. They should also be cleaned plugs
"AC" and flame detection "TC".
Following this, all parts should be thoroughly
rinsed and dried. Never wash them while they are
still warm and never use abrasive powders. Do not
allow vinegar, coffee, milk, salted water, lemon or
tomato juice from remaining in contact with the
enamelled surfaces for long periods of time.
CLEANING
Note: continuous use could cause the
burners to change colour due to the high
temperature.
WARNINGS:
comply with the following instructions, before
remounting the parts:
- check that burner head slots "T" (fig. 6) have
not become clogged by foreign bodies.
- Check that enamelled burner cap "C" (fig. 6)
have correctly positioned on the burner head.
It must be steady.
- The exact position of the pan support is
established by the rounded corners, which
should be set towards the side edge of the
hot plate.
- Do not force the taps if they are difficult open
or close. Contact the technical assistance
service for repairs.
- Don't use steam jets for the equipment
cleaning.
FIG. 6
95
Werbung
Inhaltsverzeichnis
