Commissioning; Safety Information; Assembly And Installation - Pfannenberg Quadro LED-TL Betriebsanleitung

en

5. Commissioning

5.1

Safety information

DANGER - Indicates an unusually high-level hazardous situation. Non-compliance with this warning may result
in serious irreversible injury or death.
WARNING - Indicates an unusually high-level hazardous situation. Non-compliance with this warning may result
in serious, irreversible or fatal injury.
CAUTION - Indicates a hazardous situation. Non-compliance with this warning may result in minor or moderate
injury.
DANGER - Danger to life due to electric shock
Voltage-carrying devices and exposed connection cables may cause electric shocks and serious
accidents.
 Only trained and authorized electricians may work on electrical connections.
 Disconnect all supply lines from mains before installation and secure them against reconnec-
tion. Always ensure absence of voltage.
 Wait for the discharge phase of 5 minutes for the electrical components. The device should
only be opened afterwards.
 The operating voltage must only be applied when the housing is firmly closed.
WARNING - Danger due to unauthorized use of the devices
Improper use may lead to serious accidents.
 Ensure that the connection cable is protected against pulling and twisting during installation.
The devices are only intended for fixed installation.
DANGER - Danger due to damage to the devices
Non-compliance with the information on the type plate can lead to serious accidents.
 Always observe the information on the type plate when installing and maintaining the de-
vices.
CAUTION - Risk of injury due to sharp edges or heated components
 Wear gloves during any installation, assembly or service/maintenance work.
 Perform wiring tasks at a distance from sharp edges, corners and internal components.
CAUTION - Impairment of vision

Avoid constant, direct glances into the activated lights to prevent impairment of vision.
5.2

Assembly and installation

Installation:
 Loosen the four cross-head screws in all lenses and re-
move them upwards.
The holes for mounting the housing are then accessible,
for dimensions and the recommended mounting bores
see chapter 3. Dimensions.

Perform the electrical connection in the 1st stage hous-
ing (red lens) as follows:
Connection
of the line
08/2019
Operating Instructions Quadro LED-TL
Operating voltage connection
page 4 / 6 086200010