Joie stages fx Bedienungsanleitung Seite 7

Rearward Facing Mode
(for Child under 18kg /Newborn–4 years old)
see images -
9 21
!
Please install the child restraint on the rear vehicle seat, and then put the
child in the child restraint.
i. Installation for Rearward Facing Mode
!
Please adjust the child restraint to proper angle (2 positions for rearward
facing mode). Angle indication: With top triangle and blue triangle aligned.
!
Make sure the shoulder harness is adjusted to proper height before
installing this child restraint.
!
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the waist belt are not twisted and will not stop the safety
belts from functioning properly.
1. Remove infant insert.
!
Vehicle waist belt must pass underneath infant insert.
-1
2. Pass the vehicle waist belt
9
the vehicle buckle tongue into the buckle.
9
2
1
11
over lap belt guidings, and then engage
10
10
3. Install the vehicle shoulder belt
in the two rear-facing vehicle
shoulder belt slots at the
back of the seat shell.
11
!
Vehicle shoulder belt must pass
through the rear-facing vehicle
shoulder belt slots.
!
The locking clip is used only when
the child restraint is used in the
rearward facing mode.
!
The locking clip will make the child
restraint safer.
!
Please replace the locking clip and
string in the bag when they are not
in use.
4. While pressing the child restraint,
pull the belts to fasten the child
restraint tightly and securely.
12
!
The child restraint can not be
used if the vehicle safety belt
buckle (female buckle end) is too
long to anchor the child restraint
securely.
!
Please check by moving the child
restraint back and forth.
5. Take the locking clip out of the bag.
13
!
When not in use, Top Tether MUST
be properly stored. To make sure
the top tether is properly stored
away, remove any slack in strap to
avoid the top tether swinging
around when the vehicle is in
progress.
38
11
12
13
12