Klarstein 10030930 Bedienungsanleitung Seite 41

Filter assembly
For best performance and results, the entire filter assembly should be cleaned once a week. To clean the coarse
filter and the micro filter, use a cleaning brush.
1. Remove the spray arm, contrarotate the Coarse filter and then lift it up.
2. Then lift the flat filter up.
3. If operate from step 1 to step 2, the filter system will be removed; while operate from step 2 to step 1, the
filter system will be installed.
ATTENTION: Never run the dishwasher without the filters in place. When cleaning the filters, don't knock on
them. Otherwise, the filters could be contorted and the performance of dishwasher could be debased. Improper
replacement of the filter may reduce the performance level of the appliance and damage dishes and utensils.
RCleaning the Spray Arms
• It is necessary to clean the spray arms regularly for hard water chemicals will
clog the spray arm jets and bearings.
• To remove the spray arms, screw off the nut clockwise to take out the washer
on top of the spray arm and remove the arm.
• Wash the arms in soapy and warm water and use a soft brush to clean the jets.
Replace them after rinsing thoroughly.
Protect against freezing
If your dishwasher is left in an unheated place during the winter, ask a service
technical to:
• Cut off electrical power to the dishwasher.
• Turn off the water supply and disconnect the water inlet pipe from the water valve.
• Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
• Reconnect the water inlet pipe to the water valve.
• Remove the filter in the tub and the bottom and use a sponge to use up water in sump.
41