Set-Up; Installing The Light; Installing The Wall Bracket; Inserting / Replacing Batteries - LIVARNOLUX IAN 321923_1901 Montage-, Bedienungs- Und Sicherheitshinweise

Prior to installation / Set-up
Check that the power is off using a 2-pole cir-
cuit tester.
Unpack the LED ceiling light and place it on a
non-slip base. (Be careful not to scratch it).
Apply light pressure to the plastic cover
with both hands. While pressing on it, turn the
plastic cover anti-clockwise (in the opposite
7
direction of the arrow) as far as it will go and
remove the plastic cover

Set-up

Installing the light

Before installation, ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 setting).
Hold the light fixture
tion position. Bear in mind the drill hole in the
light fixture through which the mains cable
2
will be inserted.
Mark three drill holes for the screws
Drill the holes. Be sure not to damage the
mains cable (external)
Insert the wall plugs
necessary, use a hammer to help you.
Guide the mains cable through the drill hole in
the light fixture
2
and attach the light to the ceiling.
Before the light is connected, the insulated
ground wiring must be prepared with an addi-
tional insulation.
Feed the mains connection cable (external)
through the included protective tubes
Note: Be sure to correctly connect the individ-
ual leads on the mains cable (external)
wire, black or brown = symbol L, neutral wire,
blue = symbol N, earth wire, green-yellow=
symbol
Install the plastic cover
match the cover's three notches to the correspond-
ing retaining bolts and press these upwards.
Turn the cover clockwise (right, following the
direction of the arrow) to fasten it. The adhe-
sive label with the arrow can now be removed.
20 GB
7
by lifting it up.
7
to the desired installa-
2
(see fig.).
6
.
4
into the drilled holes. If
1
provided for this purpose
.
5
4
of the light. To do this,
7
Replace the fuse or switch on the circuit
breaker (I setting) inside the fuse box.
Your LED ceiling light with Bluetooth speaker is now
ready for use.

Installing the wall bracket

Install the wall bracket
trol using the screws
9
pad (see fig.).
24

Inserting / replacing batteries

Note: The remote control
batteries (included).
Slide the battery cover (reverse) approx. 1 cm
downwards to open and then lift off the cover.
Insert two of the included AAA batteries in the
battery compartment. Ensure correct polarity.
Replace the cover and push it back to close the
battery compartment.
Your remote control

Operating the light by switch

The LED ceiling light can be switched on and
off using the wall switch. The light intensity al-
ways corresponds to the brightness level that
was last set. All other functions are controlled
solely via remote control
4

Using the remote control

: live
ATTENTION!
The functions of the remote control can only be
used after switching the LED ceiling light
with the wall switch.
for the remote con-
22
or the adhesive
23
requires two AAA
9
is ready to use.
9
.
9
9
on