Register Multiple Controllers; Unregister One Channel Or System Device; Unregister All Channels; Room Bypass - Uponor Smatrix Base PRO Kurzanleitung

UK

Register multiple controllers

CZ
Up to 16 controllers can be registered to an interface.
All additional controllers in the system must be
registered to the interface.
DE
N O T E !
At least one thermostat must be registered to
DK
the additional controller before registering to
the interface.
EE
See steps 16 and 17 in the "Register thermostat and/
or system device to a controller" section for more
information.
ES

Unregister one channel or system device

When a channel or system device is inaccurately
FI
registered or if a thermostat registration needs to be
redone, it is possible to remove the current registration
FR
from the controller.
N O T E !
HR The controller must be unregistered in the
interface as well. Go to menu Main menu >
Preferences > Link and unregister.
HU
To unregister a channel:
1. Enter registration mode. Channel 1 LED fl ashes red/
IT
green, or the fi rst unregistered channel fl ashes red.
2. If a system device (timer etc) is to be unregistered,
enter system channel registration mode. The power
LT
LED fl ashes according to the pattern long blink,
short pause, long blink and channel 1 LED fl ashes
red/green.
LV
3. Use buttons < or > to move the pointer (LED
fl ashes red) to the selected channel (fl ashes green if
NL
registered) to unregister.
4. Press the < and > buttons simultaneously for about
NO 5 seconds until the LED for the selected channel
starts fl ashing red.
PL
PT
RO
RU
SE
SI
SK
1 0
QUICK GUIDE

Unregister all channels

When one or more channels are inaccurately registered,
it is possible to remove all registrations at the same
time.
To cancel all channel registrations:
1. Enter registration mode. Channel 1 LED fl ashes red/
green, or the fi rst unregistered channel fl ashes red.
2. Press the < and > buttons simultaneously for about
10 seconds until the LEDs for all channels except
one turn off. The one remaining fl ashes red.

Room bypass

To reach the bypass settings, the controller must be
registered to the interface.
1. In the interface, go to the Room bypass menu,
Main menu > System settings > Room bypass.
2. Select a controller.
3. Select up to a maximum of two rooms.
4. Press the Confi rm button to save and exit the
menu.

Communications protocol

The system is based on a bus communications protocol
(requires the thermostats unique ID to be registered
to the controller), utilising daisy chain, direct or
star topology connections. This allows serial and
parallel connections, makes wiring and connection
of thermostats and system devices much easier than
connecting one thermostat per connection terminal.
The wide array of connection possibilities presented
with this communications protocol can be combined in
any way best suited for the current system.

Other functions

See full manual for more information about
Autobalancing of actuators (eliminating the need
of manual balancing,on by default), Heat pump
integration, Cooling, Comfort/ECO settings, KNX
module, Room check, and Supply check etc.
N O T E !
The controller must be unregistered in the
interface as well. Go to menu Main menu >
Preferences > Link and unregister.
U P O N O R S M AT R I X B A S E P R O · Q U I C K G U I D E