Risk Of Burns - Silvercrest SIKP 2000 C1 Bedienungsanleitung Und Serviceinformationen

SilverCrest SIKP 2000 C1
3. Press the On/Off button
within 10 seconds. The display (3) shows the power level in Watts (default setting 1000 W).
When it is running, the cooler fan is also running and the hotplate can hum slightly when
cooking. This is not a malfunction.
4. Use the rotary controller (8) to set the power required in Watts or press the function key
display the cooking temperature on the display (3) and adjust it using the rotary controller (8). A
beeper will sound by way of confirmation.

Risk of burns!

Do not touch the contact surface a cooking vessel has previously been standing on. After the
cooking vessel is removed, the cooking surface can still be very hot.
Use the function key
However, please note that when you switch over, the power is always set to 1000 W and the
temperature to 120 °C, irrespective of what it was set to before. So you need to make sure
your food does not burn.
Risk of fire!

Oil and fat can catch fire if over-heated. Therefore, be careful when heating oil and fat.
Never leave hot oil or fat unattended.

Risk of explosion! Never attempt to extinguish burning oil or fat with water. Instead,
smother it by covering the cooking pan with a well-fitting lid or plate. Unplug the mains
plug from the wall socket.
5. Prepare your food. While you are cooking, set the power or temperature you want using the rotary
controller (8).
6. When you are finished, switch off the induction hotplate. To do this, press the On/Off button
A beeper then sounds and the display (3) shows "L" or "H" depending on the temperature.
Warning about property damage
The cooling fan runs for a while after you switch off. Do NOT remove the mains plug from the
wall socket while the cooling fan is still running.

If you switch the induction hotplate off and the surface temperature of the hotplate is
higher than 60 °C, "H" is shown on the display. If the temperature drops below 60 °C,
the display shows "L".
14 - English
(6) to switch the hotplate on and then press the function key
(7) to switch between the power (4) and the temperature display (5).
(7)
(7) to
(6).