Bosch GKS 55 PROFESSIONAL Bedienungsanleitung Seite 16

1 609 929 F95.book Seite 4 Montag, 11. Oktober 2004 11:58 11
Adjusting the Cutting Angle
Before any work on the machine itself, pull the
mains plug.
Loosen the winged screws 7 and 15.
It is best to place the machine on the face side of
the blade guard.
Tilt the base plate away from the machine until
the required cutting angle is adjusted on the cut-
ting angle scale 5.
Tighten the winged screws again.
Note: For mitre cutting, the cutting depth is
smaller than the value shown on the cutting depth
scale 24.
Cutting Marks
45° 0°
The cutting mark 0° ( 10) indicates the position of
the saw blade for right-angled cuts.
The cutting mark 45° ( 9) indicates the position of
the saw blade for 45° cuts.
Both cutting marks include the width of the saw
blade. Always guide the saw blade off of the
drawn-up cutting line so that the required meas-
ure is not reduced by the width of the saw blade.
For this, choose the corresponding notch side of
the cutting mark 0° ( 10) or 45° ( 9) as shown in
the illustration.
Note: It is best to carry out a trial cut.
16 • 1 609 929 F95 • 04.11
Starting Operation
Observe correct mains voltage: The voltage of
the power source must agree with the voltage
specified on the nameplate of the machine.
Equipment marked with 230 V can also be con-
nected to 220 V.
Switching On and Off
For starting operation of the machine, actuate
the lock-off button 2 first, and then press and hold
the On/Off switch 1 afterwards.
To switch off the machine, release the On/Off
switch 1.
For safety reasons the On /Off switch of
the machine cannot be locked; it must
remain pressed during the entire opera-
tion.
Changing the Tool
(see figure
45° 0°
Before any work on the machine itself, pull the
mains plug.
Wear protective gloves when mounting the
saw blade. Danger of injury when touching the
saw blade.
Only use saw blades that correspond with
the characteristic data given in the operat-
ing instructions.
Do not under any circumstances use grind-
ing discs as the cutting tool.
For changing the cutting tool, it is best to place
the machine on the face side of the motor hous-
ing.
Removing
Press the spindle lock button 4 and keep it de-
pressed.
The spindle lock button 4 may be actuated
only when the saw blade is at a standstill.
Unscrew clamping bolt 22 with the Allen key 6.
Remove clamping flange 21.
Tilt back the retracting blade guard 12 and hold
firmly.
Remove the saw blade.
English - 4
)
A