Control Panel • Functions - INVENTOR PR1-30XL Bedienungsanleitung

6. CONTROL PANEL • FUNCTIONS
pOWer
By pressing the "POWER" button the dehumidifier turns on or off. The Display will turn on.
• When set humidity level has been reached the unit's compressor will
automatically stop as soon as the humidity level drops 3%-5% under the set
humidity level. The fan will continue operating for a while and will stop as
soon as the humidity remains below the desired level.
• In the event of a power failure the unit has an Auto Restart function. Once
power is restored, the appliance will automatically restart at the preselected
settings prior to the power failure.
mODe
By pressing the "MODE" button, various operations may be selected (AUTO, SHOES &
CLOTHES). While changing operation modes, device will make a short beep.
autO
Under this mode, you can set the desired humidity levels, the fan speed and the louver
swing angle. The AUTO mode indicator (AUTO) will light up. Select Auto Mode and
use the PLUS (+) AND MINUS (-) CONTROL BUTTONS to adjust the preferred settings
regarding the room's conditions.
Humidity Set Control Buttons
The humidity level can be set within a range of 40%RH (Relative Humidity) to 70%RH
(Relative Humidity) in 5% increments each time one of the relative buttons are pressed.
• For drier air press the "Minus" (-) pad to set a lower percent value (%).
• For damper air, press the "Plus" (+) pad to set a higher percent value.
Press the "Minus" button till the Display shows "CO" in order to select the
Continuous mode.
• For special humidity conditions where big amounts of condensation need
to be extracted, such as extremely moist rooms
shOes
Prior to use in this mode, the shoes dryer hose must be installed, at the hose outlet
located in the rear of the device. Select the Shoes mode and the SHOES indicator
(SHOES) will light. When selecting the SHOES function the unit operates under the
EN
9