Joie tilt Bedienungsanleitung Seite 12

4. Thread the two shoulder
harness straps at the back of
the seat onto the T-shaped
steel plate.
30
The assembled shoulder harness
straps are shown in .
31
5. Thread the shoulder harness
straps through the head
support slot to fasten the head
support to the straps, and then
pull the adjustment webbing
tight.
32
6. Reassemble the webbing cover
to the body.
33
21
30
31
32
33
Note
1. Please adjust the shoulder harness to proper height (at
or slightly above the child's shoulder) before installing
the child restraint. Please refer to
Shoulder Harness Straps
Height Adjustment.
2. Please adjust the child restraint to proper angle (3 possible
positions for forward-facing mode). Angle indication: With a
top red dot and the bottom red dot aligned, as shown in
!
Recline angle must be selected before child restraint is
installed in the vehicle. Adjusting the recline position
while child restraint is installed in vehicle may loosen
vehicle belts on child restraint, leading to serious injury
or death in a crash.
3. When installing and adjusting the vehicle belts, make sure that
both the shoulder belt and the waist belt are not twisted and
will not prevent the vehicle belts from functioning properly.
Forward-Facing Installation
see images -
34 38
1. Pull out the vehicle belt,
rotate the child restraint
forward and thread the belt
through the two forward-
facing vehicle waist belt
slots at the back of the
child restraint shell.
34
Proper Position of the
& Shoulder Harness Straps
34
.
21
22