Cleaning; Disposal - Auriol IAN 30375 Bedienungs- Und Sicherheitshinweise

= Always have a "Beep" sound at the main unit.
= Wind-chill alert was activated. When the wind-
chill alert is activated, in the 1st minute, first
10s "Beep", 2nd "Beep, Beep", after that 40s
"Beep, Beep, Beep, Beep". From the 2nd min-
ute and afterwards, it will have a "Beep, Beep,
Beep, Beep" in each minute.
= Re-set the wind-chill alert
= Annoying "Beep" sound was found when
inserting battery to the main unit.
= Inserting the rain gauge battery (the lever at
the middle position) when pairing to the main
unit. Then the rain gauge enters the test mode.
Lever at the middle position
= Lever at the left hand side position Put the rain
gauge lever to the left hand side or right hand
side first. Then insert the battery to the rain
gauge when pairing to the main unit.
WARNING! The weather station and the outside
sensor contain sensitive electronic components.
Radio waves transmitted e.g. from mobile telephones,
walkie talkies, radios, remote controls or microwaves
may influence the functionality of the weather station
and the outside sensor and lead to imprecise meas-
urements. It is therefore important to maintain as
great a distance as possible between the weather
station and the external sensor and products which
send out radio waves. Electrostatic charge can also
influence the measuring results. In this case, reset
the weather station and the external sensor. This is
done by removing the batteries and inserting them
again after approximately 5 seconds.
NOTE! All saved data is lost.
Obstacles such as concrete walls can also cause
that the reception is disturbed. In this case, change
the location (eg near a window). Please take note
that the external sensor should always be set up
within max. 25 meters (open space) from the base
station. The specified range is the free-field range
and means that no obstacle should be between the
remote sensor and the base station. A "visual con-
tact" between remote sensor and base station often
improves the transmission.
88 GB/MT
Cold (outdoor temperatures below 0°C) can reduce
the battery power of the outdoor sensor and thereby
negatively impair the radio transmission.
Another factor that may cause harmful interference,
are dead or weak batteries in the outdoor sensor.
Replace them by new ones.
If your weather station is not working correctly,
please remove the batteries for a short while and
then replace them.

27. Cleaning

Only clean the product with a damp cloth. Never
immerse the weather station, wind gauge or rain
gauge in water.

28. Disposal

The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
Contact your local refuse disposal au-
thority for more details of how to dispose
of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening